Air Chair Instructions
INSTALLING THE EYEBOLT
Locate the ceiling joint (by Stud Finder or tapping and verifying with a small nail).
IMPORTANT: Be sure to locate exact center of stud!
Using a 5/16’’ wood drill bit, drill a pilot hole (approx. 5’’ deep) perpendicular to the ceiling.
Warning! Hole must be directly in the center of the stud for maximum weight bearing capacity. Failure to do so could cause eyebolt to loosen or fall out of stud completely.
Screw in eyebolt until all threads have disappeared into the joist.
Do not back off, loosen or adjust once in place.
HANGING THE AIR CHAIR
Tie an overhand knot through the large S
hook provided using the two overhead ropes.
Be certain to maintain an equal rope length between the knot and the chair on both sides.
Hang the Air Chair from the pre-installed eyebolt via the Large S Hook.
Install the wooden dowels firmly into the dowel holders (see diagram), making sure they are firmly seated, with the longest dowel overhead, the equal dowels on the sides, and the short dowels on the footrest.
Verify all knots and dowel holders before sitting in the chair.
Warning! The Air Chair has a rated load of 350 pounds.
The overhead dowel must be level or your chair may be lop-sided.
Adjustments of one of the overhead ropes may be necessary.
ADJUSTING YOUR CHAIR
Fine-tuning of your chair is possible for maximum comfort.
Raise or lower the Air Chair height at the eyebolt, via the overhand knot.
To adjust the incline of the Air Chair, remove the overhead dowel. Adjust the slide knot (see diagram) back or forward equally on each side. Replace the overhead dowel firmly into dowel holders.
Fully reclined sitting can be achieved by setting side dowels virtually parallel with the overhead dowel. This is only recommended when you are familiar with the chair’s settings.
FOOTREST ASSEMBLY
Tie the small S hook provided to the footrest rope with an overhand knot.
Hang it from the same main eyebolt as the chair. Adjust the length so that it hangs just below the bottom of the seat of the chair.
The footrest may be adjusted up or down for further comfort.
Now, while sitting in the chair, place your heels in the center of the footrest.
IMPORTANT FINAL REMINDERS
The eyebolt must be screwed completely into a pre-drilled 5/16'' pilot hole.
Failure to adhere to this could result in injury.
The Air Chair is made of 600 Denier Nylon for added strength and durability.
Mildew or moisture does not affect the chair. It can withstand periods of exposure to the sun but will fade over time. We recommend you store the chair in the travel bag when not in use for extended periods to extend its life.
Spinning or swinging in the chair is not recommended. The eyebolt may loosen which may result in injury.
ABOUT YOUR WARRANTY
We at Air Chair believe in manufacturing a product of the finest quality.
We know that you will have many years of comfort and joy from your Air Chair.
Your chair has a 2-year factory warranty against faulty workmanship or weak materials.
Disclaimer:
Please note, Air Chair and all agents and representatives thereof cannot assume responsibility for special, indirect, or consequential damages or contingent liability for use of this product in a manner not expressly intended by the manufacturer.
End consumer is ultimately responsible for verifying proper assembly of chair as well as proper installation of eye lags according to our guidelines explained here within. We strongly recommend that you adhere to our maximum height recommendations.